How to commission wirelesshart transmitter with gateway
We are searching data for your request:
Upon completion, a link will appear to access the found materials.
Plug the Connector set into HART terminal at 375/475
Clip the other end of Connector to the COMM terminal.
Insert the Battery module into the dedicated slot
Powerup the 375/475. Select the "HART" icon and press "Enter" keypad to communicate with the Transmitter
Please wait until 475 fully load the device DD. Then go to "Configure"
Go to "Manual Setup"
Go To "Wireless"
Go to "Join Device To Network"
Key in the Network ID. Then press "Enter". The ID should be the same as configured in Wireless Gateway.
Key in the 4 parts of the Join Key. Press "Enter" to proceed. The Join Key should be the same as configured in Wireless Gateway.
Press "Enter" to Accept new join key. The device will attempt to connect with the Wireless Gateway. This may take few minutes.
Note: Depend on the device, the steps may vary. Set to the device lowest burst rate and enable gateway for "Active advertising" to speed up the connection process. The guide is for Rosemount devices.